should i buy Target Marketing Systems Berkeley reviews

Utilize limited space with the Berkeley Computer Desk. It has open design to allow for number types of office equipment, and sliding keyboard shelf and mouse surface. Constructed of stamped PVC and powder-coated steel frames, and MDF board. Computer desk measures 27.5 inches long by 19.68 inches wide by 28.35 inches high. I'll give this desk 2.5 stars. It met the requirements I needed, fits in small space, inexpensive (although there are cheaper). I read the reviews and everybody seemed to be happy with it. As far as the design goes and build quality after it was put together I give it a 4. The reason for the low score is due to the fact that some of the plastic endcaps were not included (leaving the sharp metal edges exposed), the wood is really particle board with a large wood print sticker over it. Not a big deal except that it has bubbles under the sticker and parts of the stickers were peeled back and faded. Unfortunately it's obvious this company did not believe in quality control. I say "savvy" in the title really only because I was hard pressed to find another 's' word that describes this desk. But the first two words really are accurate. While I don't use it as a computer desk, it has proved to be well put together and easy to clean. In my line of work, all sorts of grime gets onto my work surfaces. Add some feathers and its a complete disaster. So I'm not sure what it's made out of, but this desk is really easy to clean off with a little vinegar. It also does not wobble at all, or sway like you are trying to work on the back of an elephant. Or something.
The one complaint I have is the difficulty I had in putting it together. The packaging was great and everything, but it took forever to figure out how to install the roller tracks for the keyboard drawer. This was especially disconcerting because I was being timed on how quickly and accurately I could assemble the desk. As a hint to those reading, the two sections come apart when one applies a slight pressure to the small plastic tab at the end.
I ended up not using the wheels since I would not need to move the desk around, but discovered that my horribly bloated legs would not fit underneath. So it required a couple inches of raising.
The upshot: A good desk for the price. Will serve my grimy, feathery work environment for years to come. In looking around for an inexpensive mobile solution for my home studio, I came across a lot of desks that didn't quite fit my need. The Berkeley Computer Desk was the ideal solution for both the height and portability I was needing. I was also able to attach an ergotron arm for mounting my 24" monitor to the desk. Rolling it across carpet is a bit of a work out but it's a lot easier than dragging out a bunch of hardware or fumbling with my lapdesk. The slide out piece for the mouse was useless so I ended up removing it from the bottom of the keyboard tray. I also added a custom shelf to go across the lower set of cross bars so that I had a place to set my laptop. The assembly process IS a sort of feat as the instructions are not that helpful. My plan going forward is to re-enforce the back of the desk and look for larger, more durable casters. I don't expect this desk to last forever but you really can't beat the price for size and portability. The first computer desk I received seemed to be just what I wanted. I had it about 2/3 assembled when I realized the frame, specifically the piece that holds the slide out keyboard shelf, was damaged and appeared to have been packaged that way, since the packaging showed no signs of damage during shipping. Fortunately, returning was easy, but nevertheless, I had to do the assembly twice. It was also kind of confusing to figure out how to take the sliding mechanism for the shelf apart....it came as one piece for each side, but had to be taken apart for assembly, and the "picture only" instructions did not show how to do that. But all in all, after it was assembled, it's what I was looking for at a decent price. I was initially looking for a a keyboard tray to add fix on my wooden desk. After research and study, I concluded that rather than damaging my wood desk with an uncertain item which didn't get that many enthusiasts, I'd better look for a little desk with a keyboard tray. I am glad I opted for this safe and convenient solution.

I have a 27" flat iMac monitor on it, with other electronic pieces. The monitor is heavy, and the desk is sturdy, no shaking when typing.

I easily assembled it (except for my own mistakes) and quite fast (much less than an hour).

However, there are few things you might want to be aware of before this purchase, or assemble it (I'm used to putting together furniture IKEA type).

1- This desk is definitely conceived for small people like me (5'3"), if you are taller than that, you might have problems fitting your legs below (unless you have a very low seat). Anyhow, make sure you can adjust the height of your chair.

2- The mouse board is almost unusable, it is too low, and not flushed with the keyboard tray. I personally use it to put my glass.

3- On the other hand, I have a thin regular apple keyboard, and use a wireless mouse, next to each other. It works on the keyboard tray as long as you do not mind moving keyboard and/or mouse while working.

4- If you do not mind bending, and do not print a lot, the printer fits beautifully on the bottom shelf. However, if you do care, you'll be obliged to put the printer on a side table, especially when it comes to changing (too often) cartridges.

5- Yes, the wheels are not of a great quality, but on a wood floor they suffice, and allow you to move the desk without any difficulty for cleaning.

6- Regarding the assembly, it is "easy" as long as you have the right tools i.e. an electric screwdriver, a ranch, a drill, some patience and common sense. To what was said by other reviewers, I'll add:

* Follow the drawing alone. Do not get confused by the letters on the drawing and those stamped on the boards, they do not correspond (shelf N was stamped M, shelf O was stamped K).
* Watch out, the bottom shelf located on the same side you'll place your keyboard tray, and sit, is not flushed with the wheels, in order to allow you to have a (really) tiny room for your feet (I told you, you'd better be small like me). It is flushed
on the other side though.
* I'm not brilliant, so it took me a little while to separate the two parts allowing to slide the keyboard tray (G1 & G2). Instead of damaging the rail, slide open the two parts to the maximum from each other, and you'll see a little black plastic
piece to push down. This allows you to pull them apart.
* I needed an adjustable ranch to hold screw D while tightening screw C.
* Do not get confused by the"pre-drilled" holes to place the racks of the keyboard. They are not properly located.

7- This is a very convenient little desk for an amazing price, aesthetic should in no way enter into your decision. If it does, I'll advise you to look for something else.In looking around for an inexpensive mobile solution for my home studio, I came across a lot of desks that didn't quite fit my need. The Berkeley Computer Desk was the ideal solution for both the height and portability I was needing. I was also able to attach an ergotron arm for mounting my 24" monitor to the desk. Rolling it across carpet is a bit of a work out but it's a lot easier than dragging out a bunch of hardware or fumbling with my lapdesk. The slide out piece for the mouse was useless so I ended up removing it from the bottom of the keyboard tray. I also added a custom shelf to go across the lower set of cross bars so that I had a place to set my laptop. The assembly process IS a sort of feat as the instructions are not that helpful. My plan going forward is to re-enforce the back of the desk and look for larger, more durable casters. I don't expect this desk to last forever but you really can't beat the price for size and portability. I needed a small desk on casters so I could move my new computer anywhere in the house. This one fit the bill perfectly and was definitely in my price range. It was fairly easy to assemble and sturdy. Kinda hard to go wrong with this one. Took a little over an hour to assemble, just a simple picture guide, but I found it easy to understand.
It fits perfectly in the small space next to my bed in my room and appears study.
No cosmetic blemishes, was shipped in perfect condition and had two screws left over.
Good deal for the money, I'd buy another one. I'll give this desk 2.5 stars. It met the requirements I needed, fits in small space, inexpensive (although there are cheaper). I read the reviews and everybody seemed to be happy with it. As far as the design goes and build quality after it was put together I give it a 4. The reason for the low score is due to the fact that some of the plastic endcaps were not included (leaving the sharp metal edges exposed), the wood is really particle board with a large wood print sticker over it. Not a big deal except that it has bubbles under the sticker and parts of the stickers were peeled back and faded. Unfortunately it's obvious this company did not believe in quality control. I say "savvy" in the title really only because I was hard pressed to find another 's' word that describes this desk. But the first two words really are accurate. While I don't use it as a computer desk, it has proved to be well put together and easy to clean. In my line of work, all sorts of grime gets onto my work surfaces. Add some feathers and its a complete disaster. So I'm not sure what it's made out of, but this desk is really easy to clean off with a little vinegar. It also does not wobble at all, or sway like you are trying to work on the back of an elephant. Or something.
The one complaint I have is the difficulty I had in putting it together. The packaging was great and everything, but it took forever to figure out how to install the roller tracks for the keyboard drawer. This was especially disconcerting because I was being timed on how quickly and accurately I could assemble the desk. As a hint to those reading, the two sections come apart when one applies a slight pressure to the small plastic tab at the end.
I ended up not using the wheels since I would not need to move the desk around, but discovered that my horribly bloated legs would not fit underneath. So it required a couple inches of raising.
The upshot: A good desk for the price. Will serve my grimy, feathery work environment for years to come.